Скачать файл
One or more of the following fault code(s) must be stored in the ECM:
DO NOT diagnose or replace any components for the above fault(s) before performing the update function as explained in this bulletin. Improved ECM software with improved secondary air adaptation. Improved ECM software introduced in MY25 production. Update-Programming Procedure: Critical Warning: The Midtronics battery charger with at least 70A charging currentmustbe connected to the vehicle battery for the duration of the programming, to ensure the battery state of charge remains above 12.5 volts during the update process. If the battery drops below 12.5 volts, the programming could fail which may result in damage to the control module. Control modules damaged by inadequate voltage will not be covered under the warranty policy. The technician should verify the vehicle voltage prior to starting the update process, and should monitor the voltage for the duration of the update.Radiator Fan(s) may cycle ON high speed during the Update Process! There is a risk that personal injury may result if contact is made with spinning fan blades.Keep hands and objects away from Radiator Fan(s) during update process. Priorto launching the ODIS service diagnostic applications and starting control module update process, confirm tester screen saver and power settings in accordance with Special Tools and Equipment - Service Information Circular # VHW-22-13. Failure to do so may result in the tester entering power save mode during data transfer, and subsequent control module failure.Whenusing a VAS 6150/X or 6160/X tester in conjunction with a VAS 6154/X wireless transmitter head for a flash procedure, connect a USB cable between the transmitter head and the tester. Failure to do so may lead to errors during the flash procedure. VAS tools must only be used with their power adapters plugged in. Under no circumstances should they be used on battery power alone during the programming procedure.
The SVM Process must be completed in its entirety, so the database receives the update confirmation response. A warranty claim may not be reimbursed if there is no confirmation response to support the claim or action is carried out that is not explicitly stated in the Technical Bulletin.
The procedure can be found in GFF under Functions/ Component Selection, Software Version Management, Adapting Software. Ensure attached ECM/TCM Tuning Form has been completed and signed by customer.
No special parts required.
All part and service references provided in this Technical Bulletin are subject to change and/or removal. Always check with your Parts Dept. and Repair Manuals for the latest information. © 2025 Volkswagen Group Canada, Inc.All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Volkswagen Group Canada, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Library